An aluminum filter for solar EUV
A 150 nm aluminum filter with 3 nm oxide on each side, calculated from 10 to 40 nm: transmission at 19.5 nm and across the aluminum passband.
Why this design
Aluminum transmits from its L absorption edge near 17 nm toward longer wavelengths and is opaque to visible light, so thin aluminum filters sit in front of solar EUV telescopes and detectors. Both surfaces oxidize in air; this example includes a nominal oxide on each side.
Design inputs
| Input | Value |
|---|---|
| Layer 1 from the incident side | 3 nm Al₂O₃, 3.95 g/cm³ |
| Layer 2 from the incident side | 150 nm Al, 2.7 g/cm³ |
| Layer 3 from the incident side | 3 nm Al₂O₃, 3.95 g/cm³ |
| Surroundings | Vacuum on both sides, no substrate |
| Wavelength range | 10–40 nm, 301 points |
| Illumination | Normal incidence, unpolarized |
| Interfaces | Smooth (no roughness) |
Calculated result
| Quantity | Value (%) |
|---|---|
| Transmission | 69.24 |
| Reflection | 0.23 |
| Absorption | 30.53 |
What this model leaves out
The oxide thickness here is a nominal value and depends on the history of a real film. The support mesh is not included, and visible-light rejection lies outside the reference-data range, so it is not calculated.
The calculation uses bundled reference optical constants and a planar stack. It does not establish mechanical strength, thermal behavior, lifetime or fabrication feasibility.
Next steps
- Open the design in the app and confirm the inputs match the table above.
- Change a thickness and read the transmission at the target wavelength.
- Add the layers your physical film has, such as oxide, using appropriate optical data.
Calculated with the production solver from the bundled optical reference tables, not measured samples. Example-data fingerprint: 1f022e35fcfc99b7. Assumptions and data sources.