A Mo/Si mirror for the 17.1 nm solar line
A 30-bilayer molybdenum/silicon mirror tuned to 17.1 nm, the Fe IX coronal line: calculated peak reflectivity, bandwidth and angle dependence.
Why this design
Solar EUV imagers isolate individual coronal emission lines with narrowband multilayer mirrors. The same Mo/Si pair used at 13.5 nm reaches 17.1 nm, the Fe IX line, with a longer period and a thinner molybdenum fraction.
Design inputs
| Input | Value |
|---|---|
| Bilayers | 30 |
| Period d | 8.86 nm |
| Absorber fraction Γ | 0.3 |
| Absorber | 2.658 nm Mo, 10.22 g/cm³ |
| Spacer (on top) | 6.202 nm Si, 2.33 g/cm³ |
| Substrate | Si, 2.33 g/cm³ |
| Wavelength range | 15.6–18.6 nm, 241 points |
| Illumination | Normal incidence, unpolarized |
| Interfaces | Smooth (no roughness) |
Calculated result
| Bilayers | Peak reflectivity (%) | Peak wavelength (nm) | FWHM (nm) | R at 17.1 nm (%) |
|---|---|---|---|---|
| 8 | 31.39 | 16.93 | 2.04 | 31.16 |
| 15 | 49.36 | 16.99 | 1.37 | 49.15 |
| 30 | 56.56 | 17.10 | 1.08 | 56.56 |
Adding bilayers raises the peak and narrows it until absorption in the upper layers stops deeper interfaces from contributing. Past that point, more layers add deposition time and accumulated thickness error without adding reflectance.
| Angle from normal (°) | Peak reflectivity (%) | Peak wavelength (nm) | FWHM (nm) | R at 17.1 nm (%) |
|---|---|---|---|---|
| 0 | 56.55 | 17.10 | 1.08 | 56.56 |
| 7.5 | 56.19 | 16.92 | 1.06 | 51.77 |
| 15 | 55.43 | 16.42 | 0.99 | 11.70 |
| 30 | 52.24 | 14.70 | 0.80 | 0.83 |
The peak moves to shorter wavelength as the angle from normal grows, so reflectivity at the fixed design wavelength falls even while the peak itself survives. The angle rows are calculated over a wider wavelength range so the shifted peak stays in view. A mirror used off-normal needs a longer period.
What this model leaves out
An instrument channel also includes filter transmission, detector response and usually a second reflection. This page calculates a single coating. Capping layers and interlayers are not included.
The calculation uses bundled reference optical constants and a planar stack. It does not establish mechanical strength, thermal behavior, lifetime or fabrication feasibility.
Next steps
- Open the design in the app and confirm the inputs match the table above.
- Add interface roughness or a capping layer and compare against the pinned ideal design.
- Run a wavelength × angle map over your illumination range, then a thickness-tolerance analysis against your reflectivity requirement.
Calculated with the production solver from the bundled optical reference tables, not measured samples. Example-data fingerprint: 1f022e35fcfc99b7. Assumptions and data sources.